CNC Machine Operator (Entry Level)
Job Description Job Summary. Machine Operator responsible for the manufacturing of Power Section (Stator & Rotor) by following procedures and SOP Responsibilities RESPONSIBILITIES/ACCOUNTABILTY & AUTHORITY: - Manufacturing Stators and Rotors for usage in oilfield directional drilling - Follow procedures related to stator and rotor manufacturing process - Review of the necessary manufacturing procedures frequency to be fluent and aware of the critical parameters related to the process - Verify quality control checks at each manufacturing process, prior to planning or transferring the job to the next process of manufacturing - Support and participate in the Organizations Continual Improvement program and any problem-solving initiatives - Follow the operating procedures (SOP) and perform the task based on the Job Hazard analysis performed - Operation of overhead cranes in the movement of parts or products - Report any abnormalities or variations observed in the manufacturing process to the concerned parties - Ensure the tools, gauges and equipment’s used in manufacturing are maintained properly - Document and maintain checklist, paper routers, or any ERP system that are in place - Assist and support in the repair work of any machine or areas in the facility - Handling of products, tubes & core at elevated temperatures by following the necessary safety procedures - Follow the house keeping as per the 5S requirements - Suggest or raise observation on any improvements, risk, safety concerns and good practices - Ensure to comply with all NOV HSE procedures and policies and maintain relevant HSE logs - Observe HSE regulations, encourages safe working practices, corrects obvious hazards immediately or reports them to the proper personnel Behavioral Skills/Competencies & Experience Required - Perform daily operator checklist of machines - Capture/measure necessary process parameters and record the readings - Ensure controlled use of elastomer & chemicals issued to shop floor - Check the stator or rotor prior to starting any process and report if in doubt - Ensure the stator/rotor is processed to the next step only after complete review of task performed - Ensure machines are running as per the requirement - Operate Boiler, Generator, Air compressors, Forklift (License/Certification required) when needs/advised - Assist maintenance technicians when critical machine breakdowns are been attended - Provide training to any new hire / operators that are under the certification program - Other duties, as assigned by the supervisor Qualifications Qualifications: (Education/No. of Years of Experience) - High School Diploma or equivalent with knowledge in basic math Skills, Training, Special Knowledge, And/or Language Skills - Knowledge of the proper use of measuring tools/gauge and tools - Understand routers, drawings and procedures - Able to communicate in English (both writing and orally) - Understanding of pneumatic, hydraulic, basic electrical systems and with mechanical aptitude. Experience in safe use of power tools used in Manufacturing Industries Quality Assurance - Ability to understand basic engineering drawings - Ability to present and explain basic technical information to diverse audience - Ability to document, store and retrieve information as per basic QMS